Now there is interface for the B&O system

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

dhmcfadin

Full Access Member
Joined
Mar 27, 2018
Posts
553
Reaction score
240
It sall hooked up and Ive started tuning and WOW what a difference! My only sort of issue is that the input from the Zen is very low . I have the input cranked almost all of the way up in the Audio Control DSP APP and my outputs turned up and it gets plenty loud just under full volume. Would it matter if I hooked up more than one output from the ZEN to the amp? Currently I have outputs 1-2 from ZEN (right front/left front) into Audiocontrol Front (1/2) and i am getting a full range signal but it is very low. I cant imagine more inputs would do anything different as they are line level. Im going to try sending the rear doors from the ZEN out to the Audiocontrol amp and see if there is a difference. I am unable to get it to clip when setting up with pink noise source and truck volume maxed out with input maxed out in the DSP.

Have you adjusted the output level settings in the zen?
 

nah_tan

Full Access Member
Joined
Jun 4, 2017
Posts
92
Reaction score
50
Have you adjusted the output level settings in the zen?

The Zen only allows you to attenuate to -6 or -12dbfs. I have it set to -0 but I did turn the loudness on which helped some. If this is normal behavior then that's fine. Just seems like a low signal over the analog connection.
 

dhmcfadin

Full Access Member
Joined
Mar 27, 2018
Posts
553
Reaction score
240
Not sure. I didn’t have any issues and I had loudness off when using both low level and optical output.
 

nah_tan

Full Access Member
Joined
Jun 4, 2017
Posts
92
Reaction score
50
Not sure. I didn’t have any issues and I had loudness off when using both low level and optical output.

So i hooked up front doors and sub output from the ZEN to the corresponding amp inputs and now i have fade and balance working correctly and have a bit more input level and its much better.
 
Top