Take off 2018 ford raptor fox front shocks & fox rear shocks

MN DOOM said:

i have a real interest in the shocks. i have a 2011 screw with 100xxx miles and the stock shocks were rebuilt at 70xxx. so i need shocks....i was just looking into purchasing geiser springs up front to gain back a little height after i took out the leveling kit the owner before me had put in. i just need to do some research about the geiser spring and second gen shocks on a first gen. from your post it sounds like i need to retain first gen spring to fit second gen shocks on my 2011...? if i still go geiser route i would still need to order gen one springs

i should ask are the shocks even still for sale. ...

Click to expand...

MN DOOM said:

i have a real interest in the shocks. i have a 2011 screw with 100xxx miles and the stock shocks were rebuilt at 70xxx. so i need shocks....i was just looking into purchasing geiser springs up front to gain back a little height after i took out the leveling kit the owner before me had put in. i just need to do some research about the geiser spring and second gen shocks on a first gen. from your post it sounds like i need to retain first gen spring to fit second gen shocks on my 2011...? if i still go geiser route i would still need to order gen one springs

i should ask are the shocks even still for sale. ...

Click to expand...

Tx State said:

From everything I understand about gen 2 shocks on a gen 1 is you need to retain the factory gen springs. So to me that seems like you would need to buy the gen 1 geiser springs and not the gen 2.

Click to expand...

Tx State said:

From everything I understand about gen 2 shocks on a gen 1 is you need to retain the factory gen springs. So to me that seems like you would need to buy the gen 1 geiser springs and not the gen 2.

Click to expand...

MN DOOM said:

Thank you for confirming guys....long story short, im trying to regain a little height up front/stiffen up the ride with geiser springs and also need new or rebuilt shocks. i recently removed the leveling kit the previous owner installed and ave had to rebuild or replace most of the front end.....these second gens being the 3.0 should be the ticket to allow me to achieve this without throwing the geometry out of wack again...how does a fella send a Pm on this updated form?!?

Click to expand...