key fob programming

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

dewalt

FRF Addict
Joined
Dec 12, 2016
Posts
1,033
Reaction score
526
I cannot seem to find the post on programming a new remote. Does anybody have it handy?
 
OP
OP
D

dewalt

FRF Addict
Joined
Dec 12, 2016
Posts
1,033
Reaction score
526
Yes that is the key procedure. I have a new fob, and wanted to program it
 

David Nelson

Member
Joined
Jul 9, 2020
Posts
16
Reaction score
2
Location
Dexter, Oregon
Only if you use the key to start and do not have a start button. "
These Ford key fob programming instructions are all you need to ensure that keyless entry is functioning as it should!

  1. Make sure all car doors are closed. Enter the car via the driver-side door, pressing the UNLOCK button inside the doorframe.
  2. In a 10-second span, turn the key in the ignition from OFF to RUN eight times. The last turn should leave the car on RUN.
  3. At this point, you should have entered programming mode, indicated by the door locks cycling between lock and unlock. If they do not, repeat step 2, turning the key faster.
  4. Once in programming mode, press any button on your Ford remote. This must be completed within eight seconds of the door locks beginning to cycle. They will cycle again to confirm your remote has been programmed and is now ready to use.
  5. Repeat step 4 for additional remote key fobs, as needed.
  6. When finished, turn the ignition to OFF. Your door locks may cycle again as another confirmation of programming completion."
Almost the very same thing on my 2000 GMC.
 
Top