I’m sure it wouldn’t be a problem. The fitment of mine was really tight side to side, but you could always drill out the two holes (oblong) in each of the arms to account for differences in width.
Mine was water tight and aluminum. It didn’t sit any higher than the Retrax. I’m very particular about the looks of a bed cover. I can’t stand when they sit high. Throws off the proportions of the truck.
Thanks! Just used two coats of black PlastiDip and two coats of Metallic gray PlastiDip. As you can see from the bottom pic, it’ll scratch up when it encounters rocks, but you can just shoot more PD over the top and it blends in fairly well for touch ups.
Completely understand. I’ll get you a ground to top of rack measurement after work today if I remember.
Thanks for the advice on the drain tubes. I live in the Mojave, so I don’t have to worry about rain very often but will keep it in mind!
Strongly considering going with this same set up on the rack (maybe with lower legs if they have them). All direct from Front Runner? Or was there a better deal elsewhere?
I got all of mine direct from Front Runner, but there may be slightly better offers elsewhere.
For visibility, shorter...
The boards are Speedmaster. I watched a lot of videos on YouTube. There aren’t enough benefits with the really expensive name brand boards to justify their cost, so I got these. I had to drill out the mounting holes just slightly to get them to fit these brackets...
With the pups as requested.
I’m planning to move the recovery boards back a few inches. I drove around for a couple miles. At no time did they try putting their paws up on the top of the bed or tailgate. I don’t think there’s enough room for them to do it comfortably, so it achieves exactly...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.