Thanks again for the support guys. We dont want to sacrafice our quality to increase sales. We do plan on making bumpers again when we can handle the level of production involved. Everyone with orders will receive them. We have the pedal kits back from the laser and they are in powder, so...
Guys Im extremely sorry to all of you who have been trying to contact us. We lost our sales person and have since been overwhelmed with calls and orders. Due to the large volume of orders we will be stopping production of all wicked performance raptor bumpers. For all of you who have orders...
Sorry about that our phone system has been working one day and not the next. We were in the middle of a run of dead pedals when you made your order. They are all done and awaiting shipment. They should be leaving today or monday.
Rust
Our prep and powder coat is a 4 step process. The bumper is media blasted and cleaned. Then it is cleaned in an acid bath that removes and grease or oil from touching or other contamination. The bumper is then treated with a spray on rust inhibitor. We then heat the bumper in the oven...
We also make a hidden mount for winches. We dont have it on the website because there are so many variations in winches. We would be happy to send you one to see if you can shoe horn that sucker in there. I would like to know if it fits. [email protected] we can figure...
There is no benefit at all. It took about 1hr to cut the whole thing because it had to be flipped over. Because its hollow underneath to fit over the stubs on the bracket. The customer asked for aluminum so that's how we did it. I thought it was unnecessary, but a lot of things I make are. HAHA
We machined this custom badge for a customers raptor. Its Billet 6061 aluminum with his company logo in it. Just wanted to see if anyone had interest in something like this.
We actually based all of ours off the truck vault design. Theirs are also wood. They are all going to be reinforced with aluminum angle then primed, rhino lined and then interior carpet. We did it this way so that we could easily more dividers in the drawers. The drawers are able to support...
This model runs on a 12 volt system it has to batteries but the or in series not parallel. Which made it much easier for us. This is actually a 1996 model. It was built as a civilian hummer. We decided against the turret due to the cost. We do have a sliding roof and pintle mounts for...
Your looking at about 500 in material and whatever time is depending on trim and other things that get removed. The raptor screw we did was 2500$. So its not bad when you can just remove it later. Its great for a lease car because it protects the factory paint and can be removed down the line.
We are located in Ohio the truck will be headed to texas.
---------- Post added at 08:51 AM ---------- Previous post was at 08:37 AM ----------
We cut back the front fenders to give the hummer a whole new look. We will be fiber glassing in a small flair to help with spray from the tires. But...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.