Recent content by t_j

  1. t_j

    GJ Motorsports 3rd Brakelight

    Older generation of connector before we managed to source only the plug. You need to swap the wires coming from pins 3 and 5 in the small white connector at the other end.
  2. t_j

    GJ Motorsports 3rd Brake Light Wiring

    @Kmandoske ^^ The provided clips are not the best but they are fully functional, you just need to spread them a little as you are installing them. If you are worried about the paint place a little electrical tape around the opening before installing. We have had no reports of the provided...
  3. t_j

    GJ Motorsports 3rd Brakelight

    Sorry there where a small batch of modules with this reversed. Swapping the blue and red wires on the factory integration harness at the 2 pin white plug will resolve your issue.
  4. t_j

    GJ Motorsports 3rd Brake Light Wiring

    The wire coming off the factory plug should be connected the wire on the center s2 to activate the cargo light function. The S2’s will not come on unless the ground is connected, there are several ground points around the bcm to use.
  5. t_j

    GJ Motorsports 3rd Brake Light Wiring

    Must have cheeped out on the Gen 2. It’s pretty sturdy on the gen 1. You can also feed the harness under without removing the trim by gently lifting it away from the back wall of the cab and tucking the wiring in.
  6. t_j

    GJ Motorsports 3rd Brake Light Wiring

    Remove the bolt from the top (under the little cover) then pull it off. Tabs are large and would be very hard to break.
  7. t_j

    What did you do to your Raptor today? (Gen2)

    Which reseller did you purchase this from? Did it come with the S2’s installed? You do not need the bezels from the S2’s on the outside of the housing, they should be bolted in with no bezels unless you like that look, but it’s going to look a little weird and capture a lot of dirt.
  8. t_j

    My Ham Radio Install

    If you want a better ground plane, you can bond the light to the body of the vehicle and run any form of ground plane antenna. For most applications this is used for a ground plane less antenna works just fine, but as with anything the more specialized the installation/requirements the more...
  9. t_j

    My Ham Radio Install

    If you are looking for info on SWR from one of the GJ Motorsports antenna mounts take a look here https://www.fordraptorforum.com/threads/gj-motorsports-3rd-brakelight.61019/page-15
  10. t_j

    Pedal Commander! Awesomeness!

    As fun as it is digging up old threads, seems you where on to something here. I just had a customer who's RPM's would rise when they used their VHF radio to transmit on 151.625MHz, once unplugged the problem went away!
  11. t_j

    Icon 3.0 Zeta Rear shocks

    Sold sorry
  12. t_j

    What did u do to your raptor today?

    I use the one listed on the product page but I might be biased ;) there is an all black version part number BR-158-B-S which is also available via amazon.
  13. t_j

    Icon 3.0 Zeta Rear shocks

    More pictures here: https://imgur.com/a/o8pQqer
  14. t_j

    What did u do to your raptor today?

    Got round to doing some long overdue as well as some early preventative maintenance last week. * Rebuilt my 3.0 icon secondary front bypasses which was surprisingly easy * New spark plugs in the top of the block, side ones will get done in the next week or so * New air filter on the k&n intake...
  15. t_j

    Icon 3.0 Zeta Rear shocks

    Price drop $900 plus shipping! Sent from my iPad using Tapatalk

Forum statistics

Threads
92,828
Posts
1,946,515
Members
56,082
Latest member
JTRaptor20
Top