Used to dip Mint skoll but after 24 years the dentist told me id loose my lower jaw if i contiinued, so decided i better quit, so started vaping. It took me a week to make the change, but once I did, I have never dipped again. Its been about 10 years now. Vaping for me is so much better. never...
Yes the 3.0 rears on mine have done the same thing. After I installed the rears, I noticed that one of the shocks seemed to be loose inside like it wasn't tightened down to specs or something, so when i wiggled it side to side i could feel it was slightly loose where the other was not and it has...
I had the same problem with my gen one from the moment I installed fox 3.0 on the front. It got wore over time and sounded like I had a broken motor mount. After a shit load of research and going back and forth with Fox, they sad its probably worn spherical bearings on either the top and /or...
Update, Im still waiting and its now been 10 months. Has anyone ordered a set for their gen one after Dec 2021 and already receive them? Just wondering.
I bought directly from fox. Since I Installed these, I still have no clunk. still nice and quiet and I have 5 miles of dirt road anything I go anywhere If Im staying up this way, and about 60 miles of dirt road when going south to Prescot. So my truck gets a good workout and yet still quiet...
Update: I decided to just put out the money, which isn't much compared to the price of the shocks themselves, to replace the upper and lower bearings and the sleeves on both shocks to see if new ones would help. The out come was positive.
However, I think I figured out what the clunking noise...
Who's head over at fox does one need to hold a gun to, in order to get them to build a set of 3.0's that I ordered and paid for 6 months ago at RPG? This is getting ridiculous at this point. I understand the the shipping container problems but we do have other means of shipping technologies...
I am pretty sure its the bearings in either end are the problem on mine and are driving me crazy because they have worn out in less than a year and sound like I have a cracked motor mount. I had them off yesterday and the bearings are super sloppy now. The two round rubber pieces on each side at...
I know this is an old thread, but I wanted to share the tool I made so the rack can be adjusted by only removing the skid plate. This allows for a much quicker and easier way to adjust the rack. I uses an old crown nut from my Polaris General xp 4 1000 cv axle, and ground it down so that it and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.