I am working on tuning my system and have a question about input channel summing on my DSP (Dayton DSP-408). I am feeding 2 of the 8 output channels into a Kicker Hideaway HS4610 powered subwoofer. My DSP has 4 inputs coming into it from a PAC LPA2.4 active line output converter. 2 of the LOC...
That may be a possible future upgrade to it, but I already went WAY beyond what I was planning to do/spend on it. It started out as just adding a powered subwoofer and kind of spun out from there.
I finally have all of the system in and working. I swapped the Pioneer amp with the blown channel with the JL Audio JD400/4. Not only did that fix the issue with the blown channel, but the JLA sounds MUCH better and has significantly more volume compared to the Pioneer even though the RMS...
Should have just gone with the JL in the first place. Pioneer had a blown channel. Ended up returning it and now have a JL Audio JD400/4 on order to replace it.
Yeah I hear you. Sub is set to 20Hz-100Hz, door speakers front door speakers at 100Hz - 4kHz tweeters are 4kHz - 20kHz and the rear door speakers are 100Hz - 18kHz. That was just a base set to get it up and running. Once I disable the factory eq with Forscan and get the replacement amp put...
I have seen quite a few videos about different methods to install aftermarket tweeters to replace the factory tweeters in the A-pillars. I went with a set of JBL club series speakers That were the same diameter as the factory. When I started trying to figure out some sort of bracket to mount...
So the rabbit hole just keeps getting deeper. As I was going along and reading about best practices for the install, I started thinking about DSP and upgrading the tweeters as well. I ended up adding in a Dayton Audio DSP-408 And then added a pair of JBL tweetees for the A-pillars. I had not...
Spent a couple hours this morning resetting gains and swapping around cables to isolate the problem. Turns out it is a bad channel on the 4 channel amp. The amp is an inexpensive Pioneer that fortunately I am going to be able to return it and get a refund. I just ordered a JL Audio JD400/4 to...
I just completed installing the upgrades in my system and the front right door speaker is distorting badly and I can’t figure out why. I am using a PAC 2.4 active line out converter that is connected to the front speaker outputs from the head unit. From there I have 4 channels out of the LOC...
Yeah probably not much difference from a sound perspective. I did make the swap to the pioneer but it was more about the build quality and connections in this case.
More progress made on the amp rack. Got all of the power and ground cable paths laid out and marked. Now I get to drill about 100 holes so I can tie wrap down all of the runs cleanly.
Also took a little time to get a set of backup lights mounted on the Raptor. The wiring harnesses from...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.