Recent content by Prybar

Adjust it to Mid perch and be done with it. Ive had mine set on Mid since I bought the truck in 2012 with no negative results. I never even had it re-alligned and its fine.

I would run it back by the shop to make sure, but, it is probably just a sloppy job of not cleaning up after they took the filter off. Oil naturally spills down onto those cooler lines and into that plastic drip channel when you take the filter off. I always clean it all up with rags and brake...

Got some new rubbers. Also got a sweet gouge in my wheel from the tire machine. Didn't notice it until I got home and was putting the tires on the truck because the ass bags at the tire shop covered it up with a black sharpie marker!:mad::flipthebird:

Got mine set up for the tractor pulls.

One of the better mods I have done to my truck. Unfortunately, the factory locking mechanism freezes up pretty easy with the weather up here. Not the actuators fault, just a bad design.

Emergency ******.

Yeah Rick, I was super stoked just to come in under retail here in AK! A lot of benefits living up here....price on stuff like tires isn't one of them. Gald you could do better for the guys down there.

Where did you get the tailgate cover panel when you deleted the stripper pole? I looked at a new one from Ford and they were retardedly expensive. I was thinking about making one when I took the old stuff off.

I just got a set of 4 35x12.50-17s from my local Costco for 1170 including fet.

Dane, I just got them installed yesterday. I haven't had a chance to aim them yet even, but I'll do a review when I get some time with them. First impression is positive though. Bright, good cutoff, fans are very quiet, easy install. Raptizzle, can you help us, help ourselves and shut...

You may be right, but what better way to mimic some of those problems than to short wires out that go to the door switches, windows, speakers, and lock modules.

Check the wires inside the rubber loom that goes between your door frame and door. You may have to cut some of the tape loose in order to see the broken ones but I'd bet that is what the issue is.

BIRDMAN can we shut this thread down. It's beyond off topic.

Thanks Freight. I have waited until now to try the LEDs because the older ones always had terrible reviews and about the same reliability. Seems like this company has all their ducks lined up. Happy to support folks who do. I'll do a completely unbiased and unprofessional review when I get...

I just ordered a set today. Hoping to be impressed.