Recent content by notnks

Don’t buy GM! I had 2 - 2016’s, a 1/2 ton and 3/4 ton, the electronics are junk on both of them. “There are 40 computers on the trucks and all of them are designed to fail in 4 years. You won’t be able to afford to replace them, you will have to buy another new truck.“ (that statement came...

Yeah, I was holding the tears back when I was watching Lanor burn. I like the wire idea, I will start doing that. if I would have known that they used those hose clamps on my fuel lines I would have made the Ford tech change them out. lesson learned, whenever you let somebody else work on your...

I had 9000 miles on a new motor that the local Ford dealer installed. I’m not sure what was there for the first 100,124 miles, but I’m pretty sure Roush didn’t use that style of hose clamp when they modified the truck. I don’t know how the Ford Tech got back there to put the hose clamps...

I figured out what caused my truck to go up in flames... the fuel line blew apart and pumped gas all over the engine and into the insulation on the firewall. (In the picture you can see the hose clamp melted into the valve cover) Sent from my iPhone using Tapatalk

My 2011 did something similar except all my interior lights would come on randomly day and night killing the battery. On the side of the gearshift there is solenoid that tells the truck that it is in park and it went bad. Ford replaced the whole shifter and didn’t have any more issues. Sent...

I’m not real sure, shortly after I left the gas station something made an extremely loud pop noise under Lanore like a hose blowing, and she started bucking and acting like the transmission broke. I coasted down down the hill to the first intersection and pulled up by the building. That is when...

RIP Lanore Lanore, My 2013 Roush Raptor gave up the ghost last night. RIP. You will be missed!

A short update, After a new intake and gaskets, new throttle body and 2 Ford dealers, my truck is still throwing lean codes and surges just as bad as it did. After wasting 4 hours of my time the 2nd Ford dealer said they couldn't flash my ecm on my truck and couldn't help me. I think the...

Well, I just got my truck back from Ford, they think it might be the intake gasket..Ford said they couldn't get to it till later next week. If it is the intake gasket wouldn't it make one bank or the other max out on long fuel trim?

Finally got some time to mess with my truck, fuse 27 is good, and check the 3 pcm plugs, they look like new on the inside. I couldn't find the fuel rail sensor, where would they be located at? I also hooked up my cheap scan tool while driving home tonight, it was flashing O and OH, which...

This is the freeze Frame info I could get. Fuel sys B1 ; CL Fuel sys B2 ; CL fault calc load 94.90 ECT(F) ; 183 STFT B1 ; neg 17.19 LTFT B1 ; 29.69 STFT B2 ; neg 17.97 LTFT B2 ;29.69 RPM ; 2287 Veh sped ; 29 mph Spark adv. ; 23.00 IAT (F) ; 57 MAF ; 14.06 TPS ; 34.51

I had it in to one of the better mechanics near where I live and he couldn't figure out what is causing the lean codes either. He said the fuel pressure was good and the long term codes are pretty much maxed out. Except when you give it some throttle then it richens up some and the short term...

I went for a drive this morning and counted about 3 to 5 seconds between the sputters, and about 20 minutes before the check engine light comes on again with the lean codes.

Everything is stock except the muffler.

My 2011 has 95000 miles on it. The truck has been throwing the p0171 and p0174 code for several months. I have replaced all the 02 sensors, MAF, plugs, wires and put a jlt catch can on.(hoping the old hose might be the vacuum leak) I have blown smoke in the intake and didn't find any leaks. I'm...