I did mine without removing the springs (deaver +3). Just unbolt the bed. There is only 6 bolts. It gives you the room to slide the bolt out over the top of the frame rail. I just let the truck down (slowly) with the shackles unbolted. It pushes up on the bed slightly until you have the...
I'm running the same setup on the front minus the Camburg UCA and mine makes the same noise you are describing. It did it before and after I installed the fox 3.0's. I've double checked everything. I ditched the sway bar and it still does it. I'm inclined to think it is related to one of the...
I'm assuming that is because you have a 2020. My truck is 2017 with the non live valve fox 3.0's. I thought I read somewhere on here where people were talking about the newer model year trucks setting taller in the front from factory. That might be the case here. Are you running any mods on...
If I remember correctly it was only like 6 or 7 full turns from the top. I ran them how fox sets them for maybe a week then I ended up turning mine down as low as they would go. It's still about an 1.5" of lift over stock.
Did you're spreadsheet ever take off? I installed a set of 3.0s about a month ago and have been playing around with the settings. I started with the recommended setting from Fox and they are great but as others have stated it is a bit stiff for on road use especially in the rear. Anyone have...
Anyone else running the "Sport" TCM tune? I've been running this setup since Friday and came across a small issue. Curious if anyone else has had the same thing come up?
In NORMAL drive mode during light throttle situations, at about 28-30 mph, it will shift from 5-6 which is just slightly...
I figured as much. It looks pretty beefy in the pictures.
That's a lot of extra unsprung weight being added to the rear end. It's essentially adding a third wheel/tire by comparison. I love the design but it would be even better made out of a lighter weight material. I'm sure that would...
Yeah tell me about it... I ran a Forced Performance HTA3076R on my 07 STI. If I remember right it was right around $2000 with a ported/polished exhaust side.
Anybody running these yet? If so what do you think? Seems a little pricey for the gains they show. I have seen them on Full Races website for awhile now but just recently became available to buy. Here is a link...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.