I'm out in Rockford IL and have run the Stealth fighter bumper past 2 years with no plate and *knocks on wood* no tickets. I have my front plate in the truck with magnetic mounts so I can slap it on the bumper if I'm parking somewhere I think it might be checked or if I get pulled over I can...
I'm throwing in the towel. I'm on my 2nd unit as the first unit was bricked by an attempted canbus update. What's funny is the new unit has terrible audio source switching issues where as my original did not. Anyway, the main reason I'm returning it is that the SYNC system is not working like...
I see you can change the "USB type" in developer options but I cannot get my amp to connect with any setting so I can use the Android DSP app. Currently the USB will read my HD fine and let me play music thats all.
So i hooked up front doors and sub output from the ZEN to the corresponding amp inputs and now i have fade and balance working correctly and have a bit more input level and its much better.
The Zen only allows you to attenuate to -6 or -12dbfs. I have it set to -0 but I did turn the loudness on which helped some. If this is normal behavior then that's fine. Just seems like a low signal over the analog connection.
Ok I figured you could and the funky connector is simply to lock in in the correct orrientation. What outputs from the ZEN to your DSP and why? Dont you just need a single full range input into the DSP? It looks like you have 3 running?
It sall hooked up and Ive started tuning and WOW what a difference! My only sort of issue is that the input from the Zen is very low . I have the input cranked almost all of the way up in the Audio Control DSP APP and my outputs turned up and it gets plenty loud just under full volume. Would it...
I took out the B&O and built a moderate system
NavTV ZEN a2b
Audiocontrol D-6.1200
Audio frog GS690 front doors
Audio frog GB10 tweeters
Some pioneer components rear doors
(already installed)
Pioneer GMDX971 running at 1ohm
MTI Acoustics behind seat 2x10
JL audio...
Thanks for the write up. My double 10 is on its way.....Are you securing it with anything or just using the seat back to lock it in place? I dampened and foamed the entire back wall and am hoping it don't need to cut any out for the box so finger crossed. Also, how did you secure the module...
Would anybody be willing to make a video doing the simplecan update on our units? I know there is a video from phoenix out there but the menus are just a bit different and Id like to see how people are getting their USB to be recognized. Do you exit back to the unit or save and reboot when...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.