Hey everyone
So this morning I noticed the slider and driver side no longer work. Looking for some troubleshooting advice. What are the likely issues, would it be on a separate fuse, bad relay contact?
Looking for some easy steps before I start removing the seats, etc, thank you in advance
This is horrible, need to use for scan every 3 months to reset and then the learning process.
My question, can we use forscan to completely disable this? Is a huge pain in the backside.
I’m using Geon wetcoat, sounds very similar to what you are using. It keeps a bead for about 2 months. I know it says squirt and hose off but I squirt and use a small microfiber and spread it around. It might not do anything but make me feel better
Hey all, over the summer I added the heated seat icons on the main page. It wasn't until it's -2F here that I decided to turn them on. And, of course they no longer display. Any Forscan savvy people out there know how to re-enable the steering icon? Thanks in advance.
All, did the forscan temperature addition last night. Just curious what typical Temps look like? This morning the Pic is after 15 mins of highway driving at 63* ambient outside temperature
Received ford applique stickers, attempted to install myself, didn't have the little squeegee so I used a credit card. Well, on the F I caught an edge and dug into the sticker. I sent a note to Rappy stating what I did and was unhappy about the squeegee not being supplied. Would you believe that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.