Recent content by Marspool

  1. Marspool

    some help needed with pricing my truck

    Keep it, babies really don’t take up that much room...
  2. Marspool

    New member in KY

    Gen 1’s Matter...
  3. Marspool

    Gen 1 in Texas

    Gen 1’s Matter...
  4. Marspool

    Bank 2, sensor 1 Location.

    I’ve found out when it comes to 02 sensors on Gen 1’s, there are 2x on each side. It’s best to do all 4 at the same time.
  5. Marspool

    First Gen 1 Issue I’ve had..

    Thanks for the support! It’s been a good learning experience for me at the local Dealerships. I got my truck back last Tuesday after it being back at dealership for a week. It was the 5th time in 3 months! This time I broke down and itemized list and description of the trucks issues past few...
  6. Marspool

    New Raptor Pilot

    Gen 1’s Matter...
  7. Marspool

    Not a new member but got a new to me Gen 1

    Gen 1’s Matter...
  8. Marspool

    First Gen 1 Issue I’ve had..

    Yes I started at Fiesta and then to PS Motors. Going to drive to Fiesta today and see if there is anybody there that can help.
  9. Marspool

    First Gen 1 Issue I’ve had..

    That’s what I’m looking for, a “Raptor Friendly” dealership within a couple hours drive.
  10. Marspool

    First Gen 1 Issue I’ve had..

    Transmission Lead Frame-replaced Trans valve body and solenoids-replaced Trans seals-replaced Optima red top battery-replaced MAF sensor-replaced Throttle body-replaced K&N filter cleaned- No check engine or wrench right now. My obd2 scanner says no codes currently present in Drivetrain or...
  11. Marspool

    First Gen 1 Issue I’ve had..

    I called the dealership and left a msg for the service advisor, let’s see if they can come through. I have almost exhausted all other probabilities at this point.
  12. Marspool

    First Gen 1 Issue I’ve had..

    The main reason I’m anti dealer right now is the lack of competence my 2 local Dealerships have near Palm Desert California. I asked about reflashing the pcm when it went in for throttle body and they said not needed.I didn’t have any idle or dying issues until it went in for #1 transmission...
  13. Marspool

    First Gen 1 Issue I’ve had..

    These were the other two codes. Your probably onto something with cleaning out the 3 pcm connections.
  14. Marspool

    First Gen 1 Issue I’ve had..

    That’s good to know, I have not been running my A/C or heater last few months and that must be why it seems to have a lower idle rpm. As far as battery, I bought the Optima from Auto Zone last month and assumed its new, my bad for not testing...yet

Forum statistics

Threads
93,159
Posts
1,954,951
Members
56,433
Latest member
teck27
Top