Recent content by JordanSmith127

I can usually start feeling it enough to care at 55, by 70 it is super noticeable and anything over that almost feels unsafe. No change switching to 4A. First dealer I had brought it to told me they cant drive over 65 MPH to verify it. I think it has slowly gotten more pronounced or maybe I...

I have #1 on my 23 35 truck. Had the OEM 35’s before switching to a set of 37 take offs. Has been there since I bought it but the dealer try's to tell me it could be my RPG collars and wont diagnose further, they also say they dont have another Raptor on the lot to compare the vibration with...

Another happy customer, thanks @Pacific Wheel ! Ordered these on a Monday evening and had them by Wednesday of the same week. Method 305 double black +00 on OEM BFG K02 37. Also installed my 1.5” RPG collars with them.

I have a set of 5 coming off in a few days…but I am in Cali. Not opposed to shipping but it might be more costly than its worth. Shoot me a PM if interested

Holding up great. The only thing I have noticed is in a couple spots the windshield adhesive did not adhere to the appliqué once it dried. It still adds a “cushion” between the edge of the appliqué and the tailgate, however, if I look at it with a light I can see that it only bonded to the...

Completed the install today. I cleaned up my cuts with just a little bit of 180 grit, I tried to use my Dremel but it was sanding down the plastic excessively. So I just a quick sand by hand and it was enough. I then got the appliqué cleaned with Simple Green and Dawn before wiping it down...

Makes sense, I picked up the same sealant, VHB and adhesion promotor you posted. I did a rough cut on the appliqué yesterday and think I got it pretty close. Tried my dremel but like you suggested, switched over to my multi tool after cutting the first two tabs off. I am going to hit it with...

You’re the man! Thank you. I am going to go the sealant route just to be safe and will probably try and just leave the emblem attached if clearance allows. Thanks again dude

Hey Lanthas, Just had mine show up. Could you detail for me the prep work a little bit more? I am looking at the tabs and wondering if you only had to remove the grey pins or if you actually cut the black plastic base off to totally delete them. Great write up, much appreciated