Recent content by jakerjaker19

It's a Mavic 3. I grew up in Houston and often visit the Hill Country to see family but don't have any plans to drive the truck down there..Currently in Denver but have been traveling to Utah for over 20 years for desert drives. Utah is where its at for me..

I took it out here..

My 54lb Assie Shepard is my new overloading companion. Have to admit Im a little nervous hes going to destroy my 2023 Raptor interior. Hes actually pretty mellow but it's the Mud and Nails Im most worried about. So Im in the market for your favorite Interior dog hammock for front seat and...

I had a 2020 Raptor I built up for Overlanding. I ended up selling it for a 2023. Had the Roof Rack and containers, the goofy shovel and axe holders, Molly panels all over the place, the Decked System, the bed rack, awning and RTT. Ended up pretty frustrated with the rear sag. Basically...

Not sure how to post a "Want to Buy" in Garage since Im 9 posts short of being able to post. If anyone is reading this and willing to sell their factory snap rings, send me a PM and Im ready to compensate!

I curruntely have 1.5 RPG front collars, and .75 Foutz rear spacers that will be replaced with front and rear Eibach Springs. It appears the "stock" collars were removed when installing the 1.5 RPG's and either tossed or not transferred to me once completed. I do not have them. Im hearing...

Interesting. Im 2.25 RPGs and the Foutz .75 for level. A few of us use this combo. Quarter inch here and there is preference I suppose.

I’ll take a recommendation anywhere in Denver, but S Denver would be perfect. Any recommendations for a mechanic in the South Denver or Denver area that you would trust doing work on your truck? I’ve got Eibach springs to install. Looking for someone that’s had experience swapping springs...

Noticed you have 3 of the FR load bars, which is a good idea for that tent at 165 Lbs. Ive owned that tent before. How much bounce and shake did you get with that set up? I recently purchased the same FR load bars, but only two of them. I have a I Kamper mini 3 at 120lbs. I mounted the 120...

you can research this stuff on google. stay specific to Gen 2

I have four LP6's on a SPV cross bar on my 2023. Links to photos and a SPV video below. The first 4 images are my current set up with four lights. The 4th image is what SPV recommends for 100% field of view. Noticed they are bunched tightly together far right, far left. Looks fine to me...

Great question, hard to explain. Hope this makes sense. First off the RTT craze should not be for Raptors owners. Only at minimal weight. I prefer always being on the move. I do Long trips in Utah or AZ desert..some Colorado mountains. The word "Overlanding" likely has a negative...

Thats Colorado, narrow switchbacks and narrow shelf roads. The Bronco seems a great fit for you. Ive done all the high mountain stuff with an FJ over the years and moved on to infinite desert roads of the SW the past decade. Two vehicles that meet our needs. Good luck.

Added some Front Runner load bars (26lbs) to my 2023 for my IKamper Mini 3 RTT when needed. This set up does require drilling holes. These bars measure 8" above the bed allowing nice space for lightweight bins of gear if needed. This keeps the RTT below the cab and is at the very minimum...