Recent content by ivo1.cox

Hi Wilson a question, can I use this oil Bardahl XTR 39.67 Racing c60 10W 60 in my raptor, with Roush Stage 2 and your engine map? Thank you very much and many greetings from Italy Ivano Cocevari

Benvenuto al FRF have fun with your raptor beast

Benvenuto al FRF have fun with your raptor beast

Benvenuto al FRF have fun with your raptor beast

Benvenuti, enjoy whit SVT Family !!! vroammmmmmmm....

Ciao, benvenuto !! Enjoy ! whit the Beast !! :-)

No one has it connected to the 12V run and 12V LightOn, without the dimming?, Thank you !!

Good morning and Caiooo! everyone! :-) Where, what wires can I connect to the LED Gauge (Roush) the 12V RUN power and 12V light on power? I tried on the board near the right front foot but with interfered whit BCM the dimming it does not work, purple/gray PIN 40 thread(Light On) and...

Hi MTF Thanks !! if I do not start the engine how to do decrease the fuel pressure?

Hello to all !! ...it's the same, " remove the fuse of fuel pump " ? ....or is better disconnect the Fuel Pump Control Module electrical connector ? thanks to you ....and ciao ! :-)

ciao benvenuto ! enjoy whit your beast Rraappttoorr

Benvenuto, Welcome !!!

Benvenuto, welcome !

benvenuto, welcome !

Benvenuto, Welcome !