Recent content by Irvin Mendez

  1. I

    Looking for gen 2 oem matts

    I’m looking for some oem front mats for my gen 2 rappy. The ones that have the raptor logo embedded. Thanks in advance
  2. I

    Noise from back end

    @dillard09 @CoronaRaptor after what seemed an eternity, finally got her back. All bearings and pinions were replaced. Didn’t get a copy of the work order but I was there when my differential was completely stripped. Broke her right in by going straight to Baja mode. No more weird noises ✊
  3. I

    Noise from back end

    That’s a good question, I would hope all of them? Once I go pick her up I’ll see on the work order what was done. Thank you guys, honestly had it not been for your input I would’ve probably continued driving it. Looks like I dodged major damage
  4. I

    Noise from back end

    @CoronaRaptor @dillard09 so dealer said it was bad differential bearings. Said no other damage was evident. I should get it back next week ✊
  5. I

    Noise from back end

    Didn’t think of that but you might be on to something. I’ve been hauling heavy loads so that might be the culprit.
  6. I

    Noise from back end

    Hey guys, I have this strange noise coming from the back end that gets progressively louder as I pick up speed. I changed out the rear pads In hopes that would remedy the problem but no luck. I don’t notice any Changes in performance but still wanna figure out what’s causing it. Thank you.
  7. I

    Hey sir, was interested in getting your tune. Would appreciate more information. Thank you

    Hey sir, was interested in getting your tune. Would appreciate more information. Thank you
  8. I

    Bed bolts spinning

    I’ll try this first. Removing the bed seems tedious but I’m prepared to do so if that’s my last resort. My truck looks naked without the chase rack
  9. I

    Bed bolts spinning

    This was actually my 5th time taking them off, so I guess that’s the limit lol I’ll do that and probably end up getting the khc bolts. So just to confirm before I start something I can’t finish, lifting the bed will give me access to install the nut inserts?
  10. I

    Bed bolts spinning

    I been digging around and I can’t find the nut so I’m thinking somehow they got unclipped. The two front ones thread in just fine. Either I need to remove the bed to install the clips or get someone with tiny hands cuz it’s a tight fit
  11. I

    Bed bolts spinning

    I recently removed my SDHQ chase rack to load some stuff in the bed of the truck. Today I tried reinstalling said chase rack only to notice that the two middle bolts keep spinning. After further inspection it looks like the nut/clip that threads onto the bolts have fallen off. It’s a tight fight...
  12. I

    Vegas baby.

    Damn those wheels are hideous
  13. I

    Transmission temp gauge issues?

    For the past month or so, my transmission gauge shows the transmission to be cold even after warming up properly and driving around for a while. It started doing this after we got some snow and freezing temperatures. Was wondering if this is a transmission issue or just the gauge malfunctioning...
Top