Recent content by greatone99

  1. G

    Dsp input /output voltage

    yea, mine clipped at 28 ,40 hz at 28 ,and 29 at 1 kh .that being said u never really want to turn it up all the way to set gains ,either u set to 75 percent ,or 1 volume step before clipping ,and use - db 5 or 10, I use a scope ,it squeezes a little more than using a dd1 ,or even lesser ,a dmm
  2. G

    Dsp input /output voltage

    have u measured that ? mine clipped at 28 on a scope and a dd1
  3. G

    Dsp input /output voltage

    I really don’t know what I’m doing , just know enough to be dangerous.
  4. G

    Dsp input /output voltage

    I assume the 70 percent is for low recorded music ,aka headroom. im pretty happy where it is -10db as of now I've set and reset them again , at about 4v out of bit one my noise floor is gone which is about -10db on the dsp levels ,when I complained about noise floor before ,u were correct the...
  5. G

    Dsp input /output voltage

    should I set my dsp output voltage , to match the input voltage comming from the zen nav tv , with I believe is 2.1 volts rms and 6 volts max . Or do I set my dsp based on the head units output voltage, then adjust amp gains accordingly? I measure the bit one at volume 28 , 0db , bit one set to...
  6. G

    Speaker upgrade

    Agree , I bought those block off plates and sis the inner door skins . Wish I did back of the plastic door panel .
  7. G

    Speaker upgrade

    yes , I hit about 124 db at best ,with 1650 watts . my point was your not hitting 130 db with a 50 watt per channel amp
  8. G

    Speaker upgrade

    no way your getting to 130 db ,with that setup .I can't even get to 130 db with my setup .mine is a sq setup so I have plenty of power for plenty of headroom ,my speaker r only 120 watts .my tweeters r 20 watts ,I'm feeding them 75. class a ,and the mids r feed with 250
  9. G

    Speaker upgrade

    speakers will not be much of an upgrade I went down the road of front components ,and now 9000 $ and rising ,I'm still messing with it .to me for a good sq system ,u need 250 per channel up front just for the doors ,70 -125 for the tweets ,and at least 1000 for at least 2 subs 10 and up .and...
  10. G

    GEN 2 Great Audio Install

    Exactly what happened, built an entry to moderate first system for pro , 3500 ish , then I added audison 5.1 k amp , with passive fronts ,now I have active fronts , no rears , hd dsp , hd amp from audison , and pro up to 9000 ish. Without the new fronts that r like 4200$ for tweeters and mids
  11. G

    GEN 2 Great Audio Install

    the sad part is I've changed the fronts already from focal flax ,to kx2 power 2 ohms ,and now I have ordered audison thesis fronts .its an addicting hobby .
  12. G

    GEN 2 Great Audio Install

    How much roughly, I’m about 10000$ in doing it my self .
  13. G

    GEN 2 Great Audio Install

    TL3 duel voice coil 8 ohm , I wired them for 2 ohm . I believe in parallel.
Top