Recent content by DrumReaper

Tinted mine with Air80 Ceramic and it cut heat out tremendously. No issues whatsoever and I’ve had it on there for 2.5 years.

Let me elaborate a little: This 2017 Avalanche Raptor has been well cared for and has nothing but highway miles. It has never been off-roaded, mudded or raced. The ONLY mods are 35% Air-80 ceramic tint all round and on the panoramic roof, vinyl graphics to good and roof and full frontal paint...

Price lowered to $56,000.

Have to part with my baby unfortunately. Has twin-panel moonroof, forged wheels, spray-in bedliner, bed extender, heated steering wheel and rear seats. 43k miles. $60,000, obo. Located in Myrtle Beach area. Truck is immaculate. I covered the underside with Amsoil metal protectant soon as I got...

Not sure if it’s been asked or not but why was the H pipe configuration used over the X pipe? No doubt the H pipe is more throaty.

I keep hearing a CAI is no better for breathing than a K&N filter upgrade.

I have the same issue... cam phasers. They were on back order for weeks. The local ford dealership wanted to keep it as they initially thought they’d have the phasers the next day so I was off and left it with them. I asked about a rental and they said Ford wouldn’t authorize a rental. Well two...

Low ASVAB scores... gets those poor Army boys all the time! :ROFLJest:

That’s horrible. Mine are tight and aligned. I purchased a used F150 Plat SCREW a few years ago and after noticing the door gap and some overspray, found out it had been heavily wrecked and hastily put together. The dealer knew this and had told me in writing that the truck had never been...

I want to do 3 tunes to my 17 SCREW... 1) exhaust, 2) air filter (I hear CAI’s are a waste), 3) tune. With so much info out there I get lost. What do y’all recommend? Oh, and what fuel is recommended with the tune (> 90 octane or E85)?

I agree with the lot of this post but 180mph in a gt350?... stock tops out at 174mph in a nonR. How are you pulling above that?

Why about the WD40 silicon formula?

I saw a test somewheres... I’ll have to find it but Pennzoil Ultra had super good test results and heat tolerance.

Did they give you an “As Is” clause?

Which side is preferred, or better for both sides.