Thanks for the reply, I have a snap on scan tool, I scanned it a couple weeks ago. Out of town now so can’t look, but I believe it was P0106 maybe? I’ll confirm when I get home. I think I’m going to clean out all my piping and intercooler too.
I've tried searching multple times/ways and cannot find if this has already been covered. Stats: 2017, short block replaced under warranty about 12k miles ago. I replaced the stock turbos with Garrett Powermax turbos with all new oil/coolant lines about 3k miles ago. After a few hundred miles...
I installed the new evap ejector on Friday. At the time I had a pending code and a permanent code (both P144C) Now I just have a permanent code, the pending one went away. Im hoping this is fixed now. Does anyone know if the permanent one will go away as well after the correct drive cycles? Or...
I reached out last week to see if I could get a replacement evap ejector since I thought I narrowed it down to that. It just arrived. I'm going to install it and see if thats the fix. It looks different looking through the inside and the opening is a bit larger. Maybe the design was updated...
Thank you, I was suspecting that part was the problem. I will remove and inspect when I get home. I noticed on the aftermarket ones, the T piece that comes off at a 90 seems like it is threaded on. I'll check it out to make sure its not blocked.
Thanks for looking and for the reply, I already have the white beveled tube installed. Ive had it in there for a few years since I put my AFE intake on. I transferred it to the AMS inlet tubes, and made sure the bevel was facing the right way. Went so fas as to stick my inspection camera down...
Hey everyone, I posted this a few days ago in the general discussion section, but I think it may be seen more here...
I have a 2017. In December I installed Garrett Powermax turbos and AMS inlet tubes with the larger silicon adapters. I also have an AFE intake which was already on the truck. I...
I have a 2017. In December I installed Garrett Powermax turbos and AMS inlet tubes with the larger silicon adapters. I also have an AFE intake which was already on the truck. I transferred the white beveled insert tube that came with that kit to the AMS inlet tubes already. Since December, I...
I know this is a bit older post but it came up with my keyword search. I did the same mods to my truck recently. Garrett Powermax turbos, AMS inlet tubes with the larger silicon adapters. I was wondering if you had and issues with throwing an emission code. I keep getting P144C "purge...
Haven’t posted for a while. Truck has been at the dealer, got the trans replaced. Long block was also replaced when they screwed up doing my cam phasers. Now that I got it back… just finished up Garrett turbo install.
Sorry I didn’t see these sooner…All the parts finally came in and they finished the rebuild of the transmission. The most frustrating part about it all was that I feel like I was being misled the whole time. I was told parts were in, then told they weren’t. And when I would ask for an update I...
Hey everyone, I've had some shifting issues with my transmission in mu 2017 Raptor. I took it to my local dealer (Gaudin Ford in Las Vegas, NV) on October 24th. Per the conversation with my service advisor they diagnosed it, consulted with Ford, decided to tear town and overhaul/rebuild under my...
Productive week. Finished fog lights in the front bumper, front 1.5” leveling kit, afe intake, SCT tuner from 5 star tunes. Going to install rear wheel well liners tomorrow.
Sent from my iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.