I did not monitor fans so I can't give you anything on that. I can't imagine them opening when the shutters are closed or when there is decent speed going on. I didn't really notice a difference with ambient temps
Doing a little data logging, for curiosity and a comparison for when I do the cobb front mount, the shutters in front of the intercooler only seem to open under a good load (pulling long hills, no towing log yet) and when the charge temp starts getting around 120-130F area. Sometimes they will...
Got around to pulling some trim off today. This was done in a 18 raptor, so I have the mechanical parking brake. Uses the lower parking brake pedal bracket bolt to sandwich the dead pedal to the side of the truck and 2 rivnuts to hold it to the floor. It does give you a solid place to put...
Anybody install yet? Mine just arrived and a quick glance I don't see where any of the holes line up. Obviously I need to drill 2 holes for the nutserts
I just finished doing phasers on a truck today. Even if they look at the truck and confirm the noise, good luck getting parts. It took over a month of that truck sitting in the lot before parts showed up.
Anybody install a dead pedal? I have a 18 so I still have the mechanical parking brake. Only one I've found so far is the evil manufacturing one, but haven't seen or heard about it yet.
https://www.evilmanufacturing.com/dead-pedals/2016-2017-2018-ford-f150-raptor-dead-pedal-2019-2020
Heat up the coupler to soften around the sensor (heat gun works well) and it will separate. There's enough slack in the harness to move the sensor.
Mines been installed since November, no issues
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.