Fender Modification to run 37's with 1.5" Collars

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

PCDan

Full Access Member
Joined
Aug 19, 2013
Posts
146
Reaction score
86
Location
Park City
My wheels are not 0 offset they have a 6mm offset. Approximately 1/4" narrower than a 0 Offset wheel.

My bad. I remember looking at those. One of the few with any positive offset, but still over an inch out from stock. I think a +17 wheel would be perfect for looks and top fender clearance.
 
Last edited:

Turbogoat324

Full Access Member
Joined
Sep 17, 2018
Posts
731
Reaction score
431
Location
SoCal
Have you had any issues with the 37’s rubbing or hitting the inner fender on the back at stock height?
 

brettmess24

Full Access Member
Joined
Dec 13, 2014
Posts
978
Reaction score
381
Very nice! The BFG are undersized and I hate them. I wonder if this would be sufficient for Ridge Grapplers with Icon UCA Fox factory shocks and Rotiform wheels.


Thanks for the info! Need to find a welder:)


Sent from my iPhone using Tapatalk
 

Turbogoat324

Full Access Member
Joined
Sep 17, 2018
Posts
731
Reaction score
431
Location
SoCal
I have Venomrex 602’s which are +12. I wonder if I could get away with clearing the fenders both front and rear
 
OP
OP
jwpres

jwpres

Member
Joined
May 27, 2018
Posts
41
Reaction score
100
Location
Tempe, Arizona
Very nice! The BFG are undersized and I hate them. I wonder if this would be sufficient for Ridge Grapplers with Icon UCA Fox factory shocks and Rotiform wheels.


Thanks for the info! Need to find a welder:)


Sent from my iPhone using Tapatalk
I think the front fenders you would be good especially if your were lifting the front more and with UCA's. The rear fenders you may have to do a similar modification to the lower front and rear bedside flair. I was prepared to do this but after testing my wheel tire choice I determined I had enough clearance. It wouldn't be as hard as the front fender mod just more work. Or you could adjust the bump stops to remove some up travel. The photos below are after suspension mods but before fender mods. I was trying to decide how much and where I was cutting.

IMG_0803sm.jpg
Rear at full bump straight on like landing or G out. Plenty of clearance

IMG_0812sm.jpg
Full bump offset like rock crawling, pretty tight.

IMG_0808sm.jpg
Full bump offset

IMG_0805sm.jpg
Full droop you can see how I have my bump stops adjusted.
 
Top