What did you do to your Raptor today? (Gen2)

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Johnfaeglasgow

Full Access Member
Joined
Jun 8, 2019
Posts
245
Reaction score
212
Location
Kansas
So that is what the engine bay looks like when not covered in mud...50+ miles in the swamps and woods leaves plenty of marks, quite frankly, my passenger side was pretty trashed, after a lot of pin stripe removal with the DA polisher she looks a lot better, even the B pillar looks better after a water only polish on the DA. View attachment 124642
View attachment 124643
Pardon my ignorance, but what’s “DA”. My B pillars look like crap straight from the dealer and I’m unsure how best to attack. Yours look great!


Sent from my iPhone using Tapatalk Pro
 

Badgertits

FRF Addict
Joined
Jan 24, 2019
Posts
2,730
Reaction score
2,376
Location
Ma
got bored and made off road jack box/holder. All from left over crap I had laying around 2x4s and tongue and groove on bottom.

View attachment 124674
There's a thread somewhere about jacks specifically - my personal experience w/ an even larger Pittsburg brand jack (3 ton low profile) it did not get the truck high enough in front to even raise a front tire off the ground, on perfectly level concrete, I'm going to shop around for a larger/higher lift/heavier duty/larger wheeled jack personally, the eagle ones are nice but $$$

Did you try getting a front tire up? I'm talking about jacking it correctly @ the frame points not the A-arms
 

Badgertits

FRF Addict
Joined
Jan 24, 2019
Posts
2,730
Reaction score
2,376
Location
Ma
Pardon my ignorance, but what’s “DA”. My B pillars look like crap straight from the dealer and I’m unsure how best to attack. Yours look great!


Sent from my iPhone using Tapatalk Pro
I had mine covered in Xpel ultimate film when I first purchased - seems like they'll scratch if you even look @ em funny lol
 

Simplejack

Full Access Member
Joined
Jul 18, 2018
Posts
811
Reaction score
727
Location
dallas tx
There's a thread somewhere about jacks specifically - my personal experience w/ an even larger Pittsburg brand jack (3 ton low profile) it did not get the truck high enough in front to even raise a front tire off the ground, on perfectly level concrete, I'm going to shop around for a larger/higher lift/heavier duty/larger wheeled jack personally, the eagle ones are nice but $$$

Did you try getting a front tire up? I'm talking about jacking it correctly @ the frame points not the A-arms

Yep you are right I tried a couple weeks ago with this particular jack and the front tires would not get off the ground at the jack points in manual. I have a 6x6 block that I carry as well to make up the difference if and when I need it. Same boat as you as far as pro eagle jack goes, probably will regret it later but hope not.
 
Top