Husky Wheel Well Liner tip

[dmaustin]

Run a piece of tape vertically from each hole under the bed so that you can see the tape with the liner installed. Make it an inch or so longer so that it hangs beneath the liner when installed. Mark where the liner hits the tape when installed, and place a mark on the liner where the tape hangs down. Remove the liner, measure the distance from the center of each hole, to the mark you made on the tape. Once you have that length, measure up from your marks on the liner, and drill your holes.

Thank you Brother!!

 

[dmaustin]

Really? No holes up top?

My post here outlines how to install them: https://www.fordraptorforum.com/threads/husky-rear-wheel-liner.93017/post-1951142

Nope I will have to drill them. Someone else had this same issue. I guess they (husky) stopped making the holes because people were have trouble with alignment, and decided to let them figure it out.

 

[shank_guru]

That is strange. The liners I got a month or two back were from stage3 and were drop shipped to me from Husky. Plenty of holes.