Recent content by Danny

I'm in the process of making a truck cap hoist to remove and store my fiberglass cap. Having a tough time trying to figure out the actual width of my bed at the cab and then at the back so I can cut my hoisting boards/blocks to the proper length. Does anyone know how to find the overall width...

I figured out where the broken piece came from. It's on the original plug that goes to the pedal. On the side where the red tab is that you lift up on then press the black clip release in order to get the plug off the top of the gas pedal. Anyway there are 2 small black clips under the red latch...

It's about 1/2" long and about 1/8" wide and has a small VIP on the end. Does the factory clip have 2 of these where maybe I thought only one and but forcing it broke the 2nd one? I lifted the red tab on one side and used a screw driver to pry away th tab on the other but the plug wouldn't come...

Anyone have any difficulty getting the stock wire harness off? I had both the red and black clip undone but still couldn't manage to get it off. Finally did but a small 1/8" black clip snapped off. I did install both pedal commander harnesses and both clicked on. Is this good enough or should I...

Need some help! Have a 2017 Supercrew Raptor and removed the front license plate bracket in order to get the front end wrapped in film. Decided to install the bracket again and used an exacto knife to cut an "X" in the hole where the film went over the hole. Only issue, there seems to be some...