Test fitted the Gen1 beadlock rings I picked up from @badm0t0rfinger onto my 2024 37PP rims. All the bolt holes line up, as they should, because I have the SVTGen1 beauty rings mounted on them now. Now to get them powder coated and then we will see if they seal the tire correctly. Staying...
I haven’t seen the video, but basically drain fluid and spray the bajesus out of the driveshaft bolts with some PB Blaster before removing the driveshaft. Before popping it loose tie it up or bungee it to the body above so when it does pop off you can have it out of the way. Might have to pry...
Finally got around to replacing the rear pinion seal. Also replaced the mag-Hytec diff cover with a Spicer. After my last Rockies trip and dragging a rock on the rear diff after a wheel slipped off another, decided to put on a differential skid plate. Now to get rid of those cheap ass bolts...
So recently did some maintenance on the truck and saw the rear pinion seal starting to leak. Well then thought I’ll change the fluid at the same time as the seal. Then add the Foutz pinion guard/diff guard. All well and good except there’s a Mag Hytec cover on the diff and will need to be...
There are shops which can do the paint correction for you, obviously depending on how “bad” your paint is. Also cheaper than a properly prepped respray, no matter the color
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.