The only way you will be able to adjust from 20 hp to 200hp is by varying boost pressure. They only things that can do that with the push of a button are turbos, or that procharger.
The positive displacement blower is a very good option for these trucks because of one main thing, torque...
I have 325s on methods. They used to rub at full lock until I had the suspension adjusted. The Methods stick out a little more so I think stock wheels would help. They also rub the inner fender a full bump, again I think a stock wheel might bring things inward enough to avoid any issues No...
Check out Dirty Deeds, I got one used here and it's pretty good. No drone with the special tube on it. Sounds awesome.
I installed myself in the driveway. Put a ramp under passenger front and driver rear to flex the suspension to make room. Stocker goes out forward with a clockwise spin to...
I went full monty on this little project.
I put about 1/4" of expoy in the holes, wasn't sure how long the screw was.
I then ran some silicone around the inside edge where the gray pastic meets the clear, you can see the gap in there.
Then when I installed it I put a small bead under...
I saw a post about this else where. So I poured some clear expoxy into the bottom of the holes to beef things up a bit. I also plan to fill the screw hole with silicone after install.
Just pulled the trigger on a new 3rd brake light.
I did some searching here but couldn't find any threads about how to seal a new brake light to keep the water out.
Anybody got a good strategy on getting it sealed and keeping it sealed up?
Really don't want to buy another if I don't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.