Alignement specs with 3.0"s and Rogue stage 4 ?

So I know this question has been discussed a lot of times, but well I couldn't find a clear answer so...

I'm gonna drop some Fox 3.0"s on all four corners, and also Rogue UCAs, spindles, double shear tie rods and Deaver +3" on the rear...

So does anyone know some good alignment specs for this kind of setup...I read somewhere that Rogue UCAs could add some caster compared to factory specs...

So could you help ? @Jimbo @Rogue Racing

Your camber and toe should be within spec, caster will be 7.5 to 8.5 to put the wheel further forward and makes it somewhat easier to get back to straight when offroad. Look at this, it shows you where your alignment should be

http://static1.squarespace.com/stat...EIM+441610-04-40-H+INSTALL+INSTRUCTIONS-1.pdf

Oh Nice thx !