PCM

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

REBELx504

Full Access Member
Joined
Oct 24, 2016
Posts
166
Reaction score
338
Location
New Orleans
Is this after you tried the reset?

yep...vehicle starts fine...runs awesome for about 2 minutes, after warm up vehicle rpm drops below 800 and engine stalls...if you hold foot on petal and hold idle above 800 she runs GREAT, even driven all around town!!!, as soon as you let off the petal she stalls out with no codes or MIL??????
 

Hockster

My 45ft Bluewater Party
Supporting Member
Joined
Aug 9, 2010
Posts
5,142
Reaction score
1,872
Location
Winchester, Va
yep...vehicle starts fine...runs awesome for about 2 minutes, after warm up vehicle rpm drops below 800 and engine stalls...if you hold foot on petal and hold idle above 800 she runs GREAT, even driven all around town!!!, as soon as you let off the petal she stalls out with no codes or MIL??????

No tune? All 100% stock? Check the intake air for a leak. Might be a loose clamp or a tube that has moved allowing un-metered air past the MAF. Could be the TPS (throttle position switch) Sounding like it cant fine idle position.
 

REBELx504

Full Access Member
Joined
Oct 24, 2016
Posts
166
Reaction score
338
Location
New Orleans
No tune? All 100% stock? Check the intake air for a leak. Might be a loose clamp or a tube that has moved allowing un-metered air past the MAF. Could be the TPS (throttle position switch) Sounding like it cant fine idle position.

smoke test found one small crack in intake , but was very very small and repair made no change...I am leaning to either accelerator pedal or PCM
 
Top