GEN1 Deaver +2 leafs, SDHQ Bump Stop Kit, Drop Shackles

Recently put my stock suspension back on. Had this stuff put on with roughly 12-13k on my truck. Currently at 23k. I had every intention of getting off road more but sadly it didn't happen. The bump stops may have never have contacted the strike pads The truck was pretty much daily driven since I had everything installed.

Here are a few links with more info about the products.

SDHQ Ford Raptor Hydraulic Rear Bump Stop Setup with Mount

F150 SVT Raptor Deaver Rear Replacement Leaf Springs

And the Synergy boxed drop shackles were purchased later for $150

Everything = $1750 prefer pick up but will ship on a pallet

Individual

Bump Kit = $1100 plus ship SOLD
Leafs = $700 (prefer pick up, they're 95lbs each)
Drop Shackles = $100 plus ship

Approved glws

Interested in all, but where are you located? Mainly needing the deaver leafs though.

F150Feste said:

Interested in all, but where are you located? Mainly needing the deaver leafs though.

Click to expand...

Reno NV. The Deavers came shipped via UPS but anything weighing almost 100lbs a piece wont be cheap on shipping. If you have commercial address I could quote a pallet for you.

CUSTOMWHEELS4U said:

Reno NV. The Deavers came shipped via UPS but anything weighing almost 100lbs a piece wont be cheap on shipping. If you have commercial address I could quote a pallet for you.

Click to expand...

Could ship through fastenal there and deliver to a fastenal here in Dallas. 10702 N Stemmons Fwy, Dallas, TX 75220

What are the dropped shackles needed for?

F150Feste said:

Could ship through fastenal there and deliver to a fastenal here in Dallas. 10702 N Stemmons Fwy, Dallas, TX 75220

What are the dropped shackles needed for?

Click to expand...

They're technically not needed. The Deavers sat a little higher than I wanted. The drop shackle gave me more a level stance with the front on Geiser springs on low perch. I'll contact fastenal and see what they say and compare it against a pallet. I'll get back to you in the AM

PM sent

I'm interested in the bump kit, and I'm local in Reno. Let me know if its available for me to take a look.

PM sent

Sale pending for now. I'll keep the thread updated