GEN 2 Rail systems

So I have been looking at ways to incorporate a forward rail system for dirt bike tie down points, mainly a center tie down point. In my current setup, I purchased a Hi-Lift slide-n-lock tie down system and mounted to the front of the bed






This has worked perfect for my application however, I am not sure how the aluminum bed will hold up to this.

Any thoughts or other ideas on this?


Sent from my iPhone using Tapatalk

That load is spread out pretty well. I bet it holds up just fine. Just make sure you bolt it down using all the holes provided.

Yeah, it'll be fine, maybe make up a backing plate if your worried about it.

shelteredraptor said:

Yeah, it'll be fine, maybe make up a backing plate if your worried about it.

Click to expand...

Backing plate or some big ass washers to spread the load out.