GEN 1 Plumbing Roush boost gauge

Where are you guys tapping the super cheap T that comes with the Roush boost gauge.

The boost reference 4" tube? The longer tube coming off the bottom of the bypass valve?

So none of you mall crawlers have installed your own boost gauge??

So for the people who Google this and can't find an answer....

There is a plug on the top / rear passenger side of the lower intake that you pull with a torx bit. It's easy to see if you looking in the right place. There is room for a bit, extension and ratchet from the top. It's shiny and stands out like a sore thumb against the cast aluminum.

Use a 1/4" x 1/8" brass hose barb with a little thread sealant / teflon tape. Attach the ****** cheap Roush clear plastic tube to that.

Thanks for posting the answer could you include a picture.

I have to do spark plugs either today or tomorrow so I'll snap a picture and see if I can post it

Here you are

Thanks !

donk_316 said:

I have to do spark plugs either today or tomorrow so I'll snap a picture and see if I can post it

Click to expand...

Donk, what was the plug change like with the blower on.
Im about to do mine

Sucked. Did all lower 8 through wheel wells.
Passenger upper 4 very easy.
Drivers upper 2 very easy. Back 2, remove throttle body, air intake and Supercharger cast elbow.

donk_316 said:

Sucked. Did all lower 8 through wheel wells.
Passenger upper 4 very easy.
Drivers upper 2 very easy. Back 2, remove throttle body, air intake and Supercharger cast elbow.

Click to expand...

YAY.... That's what I figured