Roush LED Gauge Boost/Vacuum Raptor 2014.

Good morning and Caiooo! everyone!
Where, what wires can I connect to the LED Gauge (Roush) the 12V RUN power and 12V light on power?

I tried on the board near the right front foot but with interfered whit BCM the dimming it does not work, purple/gray PIN 40 thread(Light On) and White/Orange Pin 29 (12V Run). of BCM Board .....
:-(((((

Tap into dimmer switch, if I dim mine it leaves red on only which isn't as bright.

Sent from my XT1254 using Tapatalk

No one has it connected to the 12V run and 12V LightOn, without the dimming?, Thank you !!