GEN 1 Any Experience With Hidden Bedside Support System from SDHQ?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

t_j

FRF Addict
Joined
Sep 10, 2013
Posts
2,753
Reaction score
2,310
Location
Chicago, IL
Yes, it's an amazing setup and does a great job. Little difficult to install but worth the effort.
 

t_j

FRF Addict
Joined
Sep 10, 2013
Posts
2,753
Reaction score
2,310
Location
Chicago, IL
Thanks tj!

If you're going to do the installation yourself then I would seriously recommend picking up a right angle drill. I did mine without, and then @Jimbo's with one and it was so much easier with it. I have the rigid jobmax right angle drill head and was well worth the investment (actually it was free99 jimbo gave me the drill head for the installation).
 
OP
OP
bigrig

bigrig

Full Access Member
Joined
May 21, 2013
Posts
684
Reaction score
1,873
Location
San Jose, CA
If you're going to do the installation yourself then I would seriously recommend picking up a right angle drill. I did mine without, and then @Jimbo's with one and it was so much easier with it. I have the rigid jobmax right angle drill head and was well worth the investment (actually it was free99 jimbo gave me the drill head for the installation).

Cool, thanks for the advice!
 

Jimbo

Mad Frog Mattis
Joined
Sep 17, 2014
Posts
12,568
Reaction score
8,881
Location
IL
As long as you don't plan on going with a dovetail bumper, it'll be a good setup.
 

SDHQ

Supporting Vendor
Supporting Vendor
Joined
Aug 13, 2010
Posts
498
Reaction score
141
Location
GILBERT, AZ
I was interested in adding the Hidden Bedside Support System from SDHQ. Does anybody have any experience with this setup? If so, I would be interested in your opinion.

@SDHQ: Would there be any FRF discounts for this bedside support system?

Just saw this post, I apologize. We are a little short handed currently so it has been tough for us to keep up on the forums. Always feel free to call us at the shop though. 480-633-2929
 

SZDZMTR

FRF Addict
Joined
Sep 19, 2016
Posts
2,257
Reaction score
1,976
Location
Sewell, NJ
If you're going to do the installation yourself then I would seriously recommend picking up a right angle drill. I did mine without, and then @Jimbo's with one and it was so much easier with it. I have the rigid jobmax right angle drill head and was well worth the investment (actually it was free99 jimbo gave me the drill head for the installation).
Can you post some pics of your set up please?
 

Otis857

Full Access Member
Joined
Aug 13, 2014
Posts
796
Reaction score
504
Location
Glendale, az
As long as you don't plan on going with a dovetail bumper, it'll be a good setup.

What is the issue with Dovetailing with these kits? Do they hang down too low and show? I plan on dovetailing in the future, but still want to reinforce the bed w/o rods sticking up from the inside of the bed
 

1BAD454SS

Full Access Member
Joined
Aug 13, 2017
Posts
188
Reaction score
117
I have it on mine , not sure about installation SDHQ installed it . It does solidify the bed , i tweaked bed side carrying a heavy ass adjustable bed base frame. it was leaning on passenger side bed rail . The kit pushed it back square again.
 
Top