GEN 1 2 Gen to 1st Gen Rear Bumper Swap

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

sln157

Member
Joined
Dec 23, 2016
Posts
10
Reaction score
4
This is most likely a ridiculous question, but worth a shot. With a plethora of 2nd Gen rear bumpers for sale online at cheap prices, has anyone, does anyone know, or are there any Ford techs that would know if it’s possible to retrofit a 2nd Gen rear bumper on a 1st gen? Aside from the slimmer profile, adding a dual rear exit exhaust that lines up with the cutouts and still works with the factory backup sensors would be pretty interesting. With average prices in the $300-$400 range if it was minor bracketry mods, it’d be a pretty nice look!
 

07Alloy

Full Access Member
Joined
Apr 10, 2011
Posts
366
Reaction score
64
I asked ADD this same thing out of curiosity. They said no way would it fit. The curve and dimensions were too off.


Sent from my iPhone using Tapatalk
 
OP
OP
sln157

sln157

Member
Joined
Dec 23, 2016
Posts
10
Reaction score
4
I figured as much, I’d considered calling them or N-fab as well. After one too many crayons I thought worth asking.
 

uh_oh_6.2

Full Access Member
Joined
May 30, 2017
Posts
135
Reaction score
66
Location
Hopkins, SC
we were just talking about this on facebook FRF and I went out and took pictures of the gen 2 bumper. the mounts are close but the big issue is the corners. the corners of the gen2 fit into the fender under the taillight. effectively you would need to have fiberglass to make these fit at all.
 
Top