Yes. It's not the fan. The sound is there even when the fan isn't running. I think it's either a ground issue or possibly the amp. I'm leaning to ground since the additional ground improved it slightly.
The RCAs are shielded. They are Stinger 4000 series. I even pulled them out and ran them straight through the cab to the amp so they aren't touching anything. The noise is present even when they are unplugged. I tried unbolting the amp from the board, in case the factory amp mounted on the...
Changed my crossover to 90hz front, 95hz rear, and sub to 85hz and it sounds much better thanks for the advice.
It allowed me to uncover a new issue. A very low hiss. It's audible even withe the radio off. I checked the RCAs and even after unplugging them it's still there. I assume it is a...
I just reread this. Why do you recommend the fronts crossed over higher than the rear? I would think the 6x9 fronts would be able to handle lower than the 6.5 rears.
Thanks for the feedback
Max volume is 30 and if the clipping indicator in the Rockford is to be believed (and from what I've seen, it's as accurate as a SMD DD1) I get no source clipping at 30. I'm not sure if this is because the PAC AMPPRO pulls direct from the data bus or what. I do know that...
1. I'm planning to upgrade the door speakers to something a little higher quality with a higher power handling. The JBLs are rated at 90w front and 65w rear. The amp puts out 100w so I have the gain set lower. I have the fronts set at -5db gain and the rears at 0db with the sub at -10db. With...
I thought I would document my system upgrade.
Step one, full sound deadening.
I used Kilmat 80mil on floor and back wall of cab.
Then I did 80mil inside and outside on the doors and 50mil on the back of the door panels. I also replaced the plastic sheet on the doors with ABS block off...
I might have to take you up on that. I'm putting together my setup now So I can do a full install when the weather warms up. I'm trying to keep everything concealed and keep the floor open. That really limits me since I have to make room behind the seat for the sub and the amp. I will probably...
After looking back at the photos, I think its the light from the ZEN. It looked like an orange stain on the wires/carpet, but it's just how the light looks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.